What if you wanted a complete commercial or industrial floor? One that can withstand wear without requiring extensive maintenance, one that can look beautiful and last a lifetime, all while remaining extremely affordable? Although it may appear too good to be true, polished concrete floors are all these things and more. You can also buy the best Best Outdoor Benchtops Perth.
There are many advantages of polished concrete floors and to know about these, you can go through the points mentioned below:
High tensile strength.
Polished concrete flooring is solid and resilient and can withstand heavy foot traffic and equipment. It is tough to damage and almost impossible to chip or scratch.
Life-Span.
In even the harshest commercial environments, a properly installed, sealed and maintained polished concrete floor can be expected to last a hundred years or more. It will also outlast other floor coverings such as carpeting, vinyl tile, and wood laminates. You'll save money in the long run because you'll never have to remove and replace worn or damaged flooring. A good Concrete Driveway Perth will certainly be beneficial for you.
Simple to maintain.
Polished concrete flooring is relatively simple to keep clean. To prevent dirt accumulation, dust mop or broom sweep daily. It would help if you also damped mop, it once a week to remove smudges, scuffs, and water marks and restore the gloss. Additional maintenance may be required depending on the finish of your polished concrete floor.
Cost-Effective.
Polished concrete floors can cost as little as $2 per square foot or as much as $30 per square foot, depending on the level of complexity. Most installations are relatively inexpensive, especially if you already have a concrete slab ready for staining, polishing, or applying a decorative coating or overlay. The cost savings do not always occur during installation but somewhat over its lifetime. The only reason you'll need to replace it is if you grow tired of the look, especially when maintenance costs are considered.
There are numerous design options in the Polished Concrete Floors Perth
Today, there is an infinite number of colour and texture effects that can simulate the look of dozens of different, more expensive materials. You can also incorporate decorative engraving and stencilled graphics.
Sanitary
Concrete correctly finished and sealed can be virtually fluid resistant, particularly water. Coatings can act as waterproof barriers, sealing the concrete and preventing contaminants from entering it. Some coatings can also protect against microbes. Furthermore, high-quality concrete flooring should not have surface cracks or crevices that can trap food and dirt and harbour bacteria.
Slip-Resistant.
Any concrete surface can be slippery, especially in wet or spill-prone areas, but it can also be sealed with a non-slip epoxy coating to add texture and prevent falls and injuries.
Chemical-Resistant.
A porous non-sealed concrete floor can be sealed with a chemical-resistant epoxy coating to protect it from harsh chemicals (alkalis and acids) and corrosion.
Thermally resistant.
Thermal shock-resistant coatings can be applied to concrete flooring to prevent disbandment, delamination, cracks, bubbles, and other deterioration caused by boiling water or steam Dissipative of static electricity. Antistatic tendencies are common in unsealed concrete floors, but they are dependent on moisture levels on the floor, making them unreliable. Concrete flooring can be treated with antistatic coatings to prevent static discharge from causing damage to static-sensitive equipment.
No VOC
Unlike hardwood floors, vinyl carpets, and synthetic carpets, concrete floors do not contain harmful Volatile Organic Compounds (VOC). washes.
Conclusion
The concrete polishing process is determined in part by the desired finish. Generally, the technique entails preparing the floor by levelling it and filling it with a densifier. The floor's surface is then ground down to achieve the desired finish, whether a more matte finish or a high-gloss, mirror-like finish. Finishes that expose more of the aggregate necessitate a more involved grinding process. That type of finish, however, is uncommon in commercial spaces.